Skip to content
Search

Causes and solutions for failures in the processing of slitting and slitting machines

slitting machine metal 23

First of all, if the steel plate in the buffer pool is swaying from side to side during the slitting and slitting machine processing, to a large extent, it will directly lead to the phenomenon of uneven material collection. If this happens during the processing of the slitting machine, it is because if the steel plate in the buffer pool is swaying from side to side, the angle of entering the slitting machine will be different at this time, which will cause it to start. The receipt is uneven.

metal slitting line 32

    Immediately afterwards, in the face of the above-mentioned failures that occurred during the processing of the slitting and slitting machine, before the two sets of dividing ribs before the slitting and slitting machine, it is necessary to pay attention to the need to increase the pressure roller. In this regard, To a large extent, it can actually prevent it from shaking, so that it can enter the slitting machine equipment horizontally.

    When the slitting and slitting machine is processing, there is an uneven collection of materials caused by frequent shutdowns. The reason for this phenomenon is that to a large extent, it is actually because it is stopping or starting. At that time, there is no tension between the slitting machine and the winder, and the contact pressure with the inner steel plate will be reduced, and the sheet material will easily shift from the inner tail.

slitting line steel post 33

     When the slitter slitting machine faces the above-mentioned failures, it should be noted that it should stop as little as possible. In addition, it should be noted that the splitting pressure head should always be pressed on the coil material. Can play a certain role in improvement, so the improvement of the fault will be better.

    If the distance between the dividing plates before the slitting machine and the distance between the dividing plates on the dividing head are not set properly, it will actually lead to a large extent To avoid the unevenness of the materials. At this time, because the distance between the dividing plates and the distance between the dividing plates above the dividing pressure is relatively large, the steel plate will move left and right, which is easy to produce unevenness in the winding.

Contact Us . If you have any question, please dont hesitate to contact us . We can send you more excellent case pictures and videos . We also will definitely give you best answer.

Related Posts

Open chat
coilslitter.com
Hi,i am windy,we are a professional manufacturer to produce slitting line and cut to length line ,what can i do for you?